Behringer Xenyx X1222usb Drivers
A problem arose from the latest build. I have a Behringer Xenyx X1222USB mixer board w/builtin USB Audio Interface (which means it can act like a sound card) connected to my computer. I've used it for years, as the main microphone and instrument mixer for both music arranging (using Cakewalk's Sonar) and video netcasting (using XSplit Broadcaster). I've never had any issues being able to receiving audio input (microphones, etc.
Coming FROM the X1222USB) at the same time as sending audio output (music, sound from videos TO the X1222USB from the computer).until now. With this build, I can EITHER register incoming sound from the board OR play music, etc. The behavior goes something like this: Scenario One: I'm using XSplit for my netcast and I have both the computer's Default Recording device set to Behringer USB WDM AUDIO 2.8.40 and the XSplit preferred audio input/mic set to the same thing (as I have for years). The audio output in XSplit has always been set to Default Speakers (which are normally configured for the Behringer USB WDM AUDIO, too, with no issues). If audio input is working, I can stream/record what's coming from my board.
But anything like videos in XSplit scenes with either not run at all or they do without sound. Sometimes if I reboot and go back into XSplit, the videos, etc., function correctly, including sound, but no microphone input is registered coming from the board. Scenario Two: If the audio input from the Behringer X1222USB board is working (verified by pulling up the Recording Devices system tray applet) and try to play something from the Groove app I get the attached errors and a message that it can't play the songs because an audio device can't be found. These are just the more common examples of only being able to bring audio in or out, but not both, using this USB device. My troubleshooting steps have included: Using the actual Windows Audio Troubleshooter - No improvement Completely removing the Behringer device from Device Mgr, uninstalling the ASIO4ALL drivers for the mixer, rebooting, reinstalling the drivers and re-connecting the board - No improvement Re-acquiring the latest ASIO4ALL drivers from Behringer and installing them - No improvement.
I've even gone so far as rolling BACK to the previous build, with no improvement. I believe whatever the update did, it did it as such a level that even rolling back doesn't change it. I'm desperate. There has to be some way to find out what exactly is happening.
Behringer Xenyx X1222usb Software
I can find nothing in the Event Viewer to hint as to what it might be. But clearly, as a basic level, something has happened to make a mixer board with a USB audio interface not function in a duplexed mode.
Behringer Xenyx X1222usb Software Download
I'm hoping there's some sort of registry entry or something else that will help.